Déverrouiller le password root via le moniteur

Des cubes et des boites à pizzas noires

Modérateur : Politburo

Répondre
Avatar du membre
FlyingNono
Fonctionne à 2400 bauds
Fonctionne à 2400 bauds
Messages : 1940
Enregistré le : 05 déc. 2003 20:26
Localisation : (encore dans les cartons)

Déverrouiller le password root via le moniteur

Message par FlyingNono »

Salut,
Je viens de redémarrer mon Cube pour y faire l'intégration propre d'un lecteur de disquette (utile pour la 1ère installation) et un lecteur cd pour remplacer le magnéto (mort comme d'hab)
Démarrage ok, password et euhhhhhh impossible de retrouver le password :|
J'ai cherché et trouvé ça : http://www.nextcomputers.org/forums/vie ... php?t=2650
Je n'ai pas testé la partie Intell, mais la 1ere partie (black-hardware) m'a permit de déverrouillé la session root
Nickel :wink:
Par prudence, je copie-colle ici

Petit détail: l'accès au moniteur se fait avec la touche "command-droite" + touche "en haut à gauche du pavé numérique"
la touche tilde "~" du qwerty devient la touche "<" sur un clavier azerty.
il faut rebooter, donc effectuer un 2ème démarrage après un arrêt/marche effectué via l'interface, ensuite bsd -s fonctionne parfaitement.
(j'ai essayé plusieurs fois, après un démarrage de 0, la commande bsd -s n’aboutit pas)

Black hardware:

Reboot the system.
Immdeiately after the "Testing System" message is replaced with "Loading from disk", hold down the right command key and press the tilde (~) on the numeric keypad. You are now at the ROM monitor.
Boot the machine into single user mode. Most people boot off the hard disk, and should type the following at the ROM monitor prompt:

Code : Tout sélectionner


NeXT> bsd -s
Once the system has started and dumps you at a root prompt, you need to make sure NetInfo and other services get started. Do this by typing:

Code : Tout sélectionner


sh /etc/rc &
Set the root password using:

Code : Tout sélectionner


passwd root
Now, reboot the system and you can use the new password.


Intel hardware:

Reboot the system.
Boot the machine into single user mode by typing the following at the bootloader prompt:

Code : Tout sélectionner


NeXT> bsd -s
Once the system has started and dumps you at a root prompt, you need to make sure NetInfo and other services get started. Do this by typing:

Code : Tout sélectionner


sh /etc/rc &
Set the root password using:

Code : Tout sélectionner


passwd root
Now, reboot the system and you can use the new password.
Modifié en dernier par FlyingNono le 03 mai 2022 17:03, modifié 1 fois.
J'ai un phaseur, un générateur de changement d'état physique, je n'hésiterai pas à m'en servir !
Avatar du membre
gege
Fonctionne à 14400 bauds
Fonctionne à 14400 bauds
Messages : 7141
Enregistré le : 31 janv. 2008 14:24
Localisation : Banlieue Paârisienne
Contact :

Re: Déverrouiller le password root via le moniteur

Message par gege »

Bonjour,
Merci ça servira !!
G.E.
Répondre

Retourner vers « NeXT »