Basic program SN ERROR casio Z-1

[miguel]

hi all . i buy a casio Z-1 and i try to write some command in a basic program but i have error all time.
First i push menú and 2 to go basic mode programing then i write

10 PRINT CHR$(232)

RUN

SN ERROR LINE 10

i have another casio fx-750p and when i write line 10 and run program show the apropiate character

i some can help me to program in this computer i apreciate.
thanks.

[remy]

I just tried on PockEmul and this code works perfectly.
Perhaps the memory is not well initialized... try a Reset.

z1_1.jpg (99.21 Kio) Vu 4303 fois

z1_2.jpg (96.94 Kio) Vu 4303 fois

[miguel]

Hi again i push from button
And i try ti push back button too.
This reset ?
Or how reset?
Thants.

Code not work after push buttons.
Mayte i forget some?

[remy]

push the ALL RESET hole with a pin (below the TAB key)

[gege]

Hello
Incredible you managed to wear the Enter key on Pockemul !!
Could'nt imagine this was possible.
Probably huge usage with time…

G.E.

[remy]

Yes!!!
PockEmul manages to worn the key based on the press count.
It is all of these undocumented features that make PockEmul more realistic.

[gege]

Wow
From now on I'll open the application more carefully lest I break some LCDs !

And not only this, but also in the Properties menu, I just found a WAF value which cannot be modified and Always decreases no matter how many luxury Pockemul modules you purchase !!!
Top realistic !

A bit frightening even…
Good work
G.E.

[remy]

You're absolutely right.
because of the Sharp PC-125x lcd sickness, I will have to deal with the black spots.

But seriously, it could be be a funny feature. Adding an option in settings : "silly features".
I will start to make a list:
- Key worn based on press count
- LCD damage
- the red line at the end of the paper roll on the printer
- ...

I just open a ne thread about this: http://www.silicium.org/forum/viewtopic ... 64&t=46336

[torgamm]

Ah you were not serious? What a pity!

I was convinced that, by design, PockEmul was showing Casio keyboard worn out as it should be, while this was not happening with my superior Sharp PC-1500 keyboard

[miguel]

i press button all reset in basic mode
then i go basic mode and write

10 PRINT "hello"
20 PRINT CHR$(232)
RUN

hello
SN error P0-10

maybe i need write funtion to write graphics or some else?

[miguel]

sorry the error is in line 20

[remy]

so the "Hello" is printed ?
perhaps an issue with the $ sign ?

Very strange

[miguel]

yes hellow is printer after run
then error in next line

[remy]

Are you sure to use () and not <> ?
I know this is obvious but the issue can only come from $,( and )

[miguel]

Yes shift S and shift T y use in keyboard