FlyingNono a écrit : ↑02 mai 2022 17:15
le premier truc à faire avec le voltmètre c'est de mesurer la tension à vide (il me semble que c'est de l'alternatif) et voir si le câble est ok
D’après le
hpmuseum voici les tensions et la polarité du connecteur du chargeur (le point du milieu est la masse, à gauche c'est la tension pour charger la batterie, à droite pour alimenter la calculatrice):
"Output 3.6-4.7 V DC @ 150-190MA calculator, and 4.2 V DC @ 50-60 MA battery charger. (Exact specs vary slightly with charger model but chargers are interchangeable.) A complete recharge takes 14 hours with the calculator on or off. The batteries are low when extra decimal points are displayed.
Looking at the plug, the center terminal is marked negative. The left terminal is marked + and charges the batteries and the right unmarked terminal (also positive) supplies operating power. (The battery charger circuit is current limited and will typically read much higher than 4.2 V without a load.) When the power plug is removed, a spring connects the left and right terminals allowing the batteries to power the calculator."
FlyingNono a écrit : ↑02 mai 2022 17:15
pas forcement,
Le Nicd sont assez solide.
Avec des NiCd qui ont coulé je ne prendrait pas le risque de les réutiliser, mais je suis peut être trop prudent.